Progression Fitness B890P Bedienungsanleitung

Magnetic Upright BikeModel: B890POwner’s Operating Manual

- 9 -E6E5L2 MK9K10NA20A21

- 10 -No. DescriptionA1 Main Frame 1A2 DRIVING WHEEL SET 1 SETA2-1 Driving Wheel 1A2-2 Axle 1A2-3 Spring Washer 8A2-4 Screw 4A2-5 Nut 4A2-6 Ax

TIME: Count up - No preset target, time will count up from 00:00 to maximum 99:59 with 1 second increments. Count down - If training with preset t

To set function value for TIME, DISTANCE, CALORIES, PULSEin sleep mode.To select training mode and adjust function value up.To select training mode an

P01P02P03P04P05P06P07P08P09P10P11P12CLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWI

CLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCK

CLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCK

CLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCKWISE ORCOUNTER-CLOCKWISECLOCK

1. BODY FAT - This is a figure that is determined using your personal data and the signal measured when user’s hand is placed on the heart rate se

- 1 - (L2)Water bottle(K9) SCREW M6X15mmBook Stand(K10) M6 Adapter

- 2 - ASSEMBLY OF FRONT STABILIZERUse two bolts (K1) and two washers (K2)to secure the front stabilizer to thefront of the main frame (A).HOW TO KEEP

- 3 - ASSEMBLY OF CENTRAL SUPPORT TUBEFirst, remove the bolts (D4) and washers (D5) fromthe central support tube (D).Step 1. Connect the cable (D2) w

ASSEMBLY OF HANDLEBARFirst remove the washer (E8) and nut (E9) fromthe handlebar (E). Secure the handlebar in the housingusing washer (E8) and nut (E

Step 2: Slide the sensor wires (A8 & E4) through the monitor front housing (K4) as shown inView A). Then connect the monitor rear housing with m

- 6 - G6G4G3G3ASSEMBLY OF SADDLE & SADDLE SUPPORT TUBEStep 1: Loosen the screw (G6), washer (G4) and knob (G3) from the saddle (J), and position

PEDALS ASSEMBLYSecure the pedal (H2-R) and (H1-L)to the crank using clockwise (H2-R) andcounter clockwise (H1-L) rotation.ASSEMBLY FOR BOTTLE HOLDER &

- 8 -HOW TO MOVE THE MACHINEStand at the back of the machine and lift it up until the weight of the machine is transferred tothe transport wheels. Yo